Boltek LD-350 - Manual (Page 16)

O P E R A T I O N
11
Rear Panel Connectors
Lightning Antenna
Connect the supplied Antenna cable (standard Cat5e) from the antenna to this connector.
GPS
If the optional LTS-3 Timestamp card is installed, the RJ45 connector end from the GPS cable
connects here. The other end of the cable will have a round metal connector that attaches to the
GPS receiver.
USB
Connect the provided USB cable here and attach other end to an available USB port on a Laptop or
PC. This connection is needed to display lightning strikes on the NexStorm or Lightning/2000
software.
Network 10baseT
Used for connecting the LD-350 to a LAN hub or router when optional LTS-3 Timestamp card is
installed. This port transmits data to a lightning detection network server for higher accuracy strike
location when used with multiple detectors. The LD-350 is preconfigured to automatically connect
to the Boltek Lightning Network if an internet connection is detected. Note: This connection is only
enabled when the LTS-3 Timestamp Card is installed.
Power
Connect supplied 12V DC power supply to this connector
Ground
Connect a grounding wire to a suitable ground point for proper operation and to provide better
protection against external electrical noise and interference.