ReadyLIFT Ford Raptor 2010-2014 - Uniball Lower Control Arm Kit - Pair - Manual (Page 6)

www.ReadyLIFT.com - Phone: (800) 549-4620
Installation Instructions 44-2303
6
Revised Feb‐14
Tighten down the top c-lock nut on the LCA uniball. Then re-install the
CV joint seal. 21.
Re-install the axle into the spindle. Make sure to line up the teeth. Rotate to
ensure that there isn’t anything bound up inside. Re-install the nut and
the dust seal on the end of the axle. 22.
Re-install the rotor and brake calipers. Re-attach the ABS lines, brake
lines and vacuum line to the spindle. 23.
To use the factory Sway Bar you must purchase Kit # 67-2999. Install new
sway bar end link brackets to the sway bar. If not using factory sway bar this
would be the time to remove it from vehicle. 24.
Install the sway bar end links to the LCA. Then install the top of the link to the sway bar.
If not using Kit # 67-2999 install supplied socket head allen bolt to cap sway bar
mount for future use and to protect the thread bung. 25.
Install the sway bar end links to the sway bar bracket.
Install the nut to the outside of vehicle 26.
Re-attach the tie-rod to the spindle. 27.
Torque everything down to factory specifications and recheck the installation
to ensure it was done properly. Put the tires on the vehicle and set it on
the ground. The vehicle must be aligned prior to driving . 28.