Nematron M-Series Monitors - Manual (Page 15)

15
Protective Cover Installation
(Optional if desired)
Step 1: Gather the parts of the protective cover; top shell,
bottom shell, label insert, and wire tie. The
picture shows wire tie (top), label insert (right),
bottom shell (left), and top shell (lower right).
Step 2: Insert your pre-wired connector (with the screws
facing up) into the bottom shell. (See manual
for cable wiring instructions).
Step 3: Insert the wire tie from the bottom shell, loop around
the cable and come back out of the opposite
hole in the bottom shell.
Step 4: Tighten the wire tie around the cable and the
bottom shell.
Step 5: Seat the top shell onto the bottom as shown. Insert
label strip (if desired) in slot on top shell and
bottom shell.
Step 6: Snap the top and bottom shells together.