Nexo GEO S8 - Manual (Page 25)

GEO TANGENT ARRAY RIGGING SYSTEM P.25
Combination GEO/CD12 bumper
It is possible to make a single bumper by using the connecting bar to join the GEO bumper and the CD12
bumper. The cluster will then consist of:
• The GEO enclosures, attached to the GEO bumper
• The CD12 enclosures, attached to the CD12 bumper directly behind the GEO array
• The connecting bar which joins the entire array assembly together.
The procedures for attaching GEO loudspeakers and CD12 enclosures to their respective bumpers are the
same as previously explained.
The connecting bar must be passed through the bodies of both bumpers and locked in position using two
12mm pins for each bumper. These 12mm pins use the same R-clips as on the GEO pins (see Figure 10).
NOTE: The list points of the CD12 Bumper are positioned on the centre of gravity of the CD12. They are
offset from the centre of the tube to allow the correct positioning when assembling a combination GEO/CD12
bumper.
If you are assembling left/right stereo arrays as described in section IV-1, you must reverse the CD12 bumper
in order to maintain the correct orientation with respect to the GEO Array. In a frontal view of the cluster, the
GEO array must be centred with respect to the CD12. (see Figure 11).
CAUTION: In this configuration, the CD12 Bumper is designed to hang a maximum of 8 CD12
enclosures.
Figure 10 Figure 11