Nexo RS - Manual (Page 28)

Page 28/54 RS18 R IGGING I NSTRUCTIONS
5.2.3 Adjusting rigging point for horizontality
Before connecting a second cabinet, bumper angle has to be adjusted for perfect horizontality.
This requires that the rigging point is adjusted in the two horizontal directions so that the bumper
remains horizontal within +/-1°. Adding cabinets will improve this tolerance.
Adjusting 0° along the cabinet depth
Adjusting horizontality along cabinet depth is done by properly selecting bumper hole:
GRIDS SAME SIDE
5.2.4 Flying subsequent RS18s
• Lift assembly to sufficient height in
order to connect a second RS18;
• Position and align second RS18
below assembly;
• Remove the 4 quick release pins from
the PARKING position so that sliding
connector plate can be moved;