Nexo STM Series - Manual (Page 4)

4
FLYING MODES
There are 6 flying modes that can apply depending on design and motor variables:
-
2 modes in single motor
- 4 modes in double motor.
Below table describes these modes and lists parts required. Additional parts according to cluster
configuration are listed next page
GENERIC
Double motor points, all angles (≤24)
1&2 Front and rear motors
3
Compression chain
Components:
1xXBOW + 1xPTILT + 1xKBEAM + 1xBCCH + page 5
NO FRONT CLUSTER CLEARANCE
Double motor points, negative angle (≤24)
1&2 Front and rear motors
3
Compression chain
Components:
1xXBOW + 1xMLINK + 1xKBEAM + 1xBCCH + page 5
NO FRONT AND REAR CLUSTER CLEARANCE
Double motor points, Levalift, all angles (≤24)
1&2 Front and rear motors
3
Levalift
Components:
1xXBOW + 2xPTILT + 1xLEVA + page 5
EXTREME POSITIVE UPTILT
Double motor points, Levalift, high positive angles (≤16)
1&2 Front and rear motors
3
Levalift
Components:
1xXBOW + 1xPTILT + 1xKBEAM + 1xLEVA + page 5
SINGLE MOTOR UPTILT
Single motor point, Levalift, positive angles (≤12)
1&2 Bridle
3
Levalift
Components:
1xXBOW + 2xPTILT + 1xBRIDLE + 1xLEVA + page 5
SINGLE MOTOR DOWNTILT
Single motor point, Levalift, negative angles (≤12)
1&2 Bridle
3
Levalift
Components:
1xXBOW + 2xPTILT + 1xBRIDLE + 1xLEVA + page 5
NB: Points #4 (
∆∆
) are for safety connection
.