Avaya 3600 Series - Manual (Page 30)

Avaya Inc. Desktop Charger, Dual Charger, and Quad Charger User Guide
General Care of the WT and Chargers
This section applies to all WTs, the Docking Station and all
AVAYA chargers.
Do not drop Avoid dropping the WT or knocking it against hard surfaces.
Carrying the WT in a holster or carrying case will help to protect it.
Do not disassemble
There are no serviceable parts in the WT, Docking Station or
chargers. You should not open the WT case nor disassemble the
Docking Station or the chargers. Doing so will void your warranty.
Cleaning tips Turn off the WT and unplug the Docking Station and chargers
before you clean them. Never immerse either in water. Clean the
exterior surfaces, including the charging contacts, with a cloth that
has been slightly moistened with water. Take care not to exert
undue pressure on charger electrical contacts while wiping.
Wiping the handset and Docking Station surface with a water-
dampened cloth or paper towel will remove most films or residues.
If the soiling is too stubborn for plain water, a mild detergent
solution may be used. Be sure to wipe away any detergent residue
with a clean water-dampened cloth.
The WT and Docking Station may be cleaned with any general-
purpose household glass and surface-type cleaner. DO NOT
SPRAY THE HANDSET DIRECTLY!
Pre-treated cloths such as used for eyeglasses or cameras may be
used to clean the handset and Docking Station. Pre-moistened
towelettes may also be used to clean the phone, however, avoid
those containing lanolin or aloe as it will leave a slippery residue.
The surface of the handset and Docking Station may be cleaned
occasionally with disinfectants used for general cleaning in a
medical environment. Isopropyl alcohol may be used
occasionally applied by a damp cloth or paper towel. When
using alcohol, do not rub the keypad characters vigorously.
Doing so will significantly degrade legibility.
• Do not use furniture polishes, waxes or plasticizer-based
cleaner (Armor All
™, etc.)
• Do not use lanolin, aloe, glycerin or other skin care type
products.
• Do not apply any solvent such as acetone, mineral
spirits etc.
•
Do not directly spray or immerse the handset.
Headset cleaning Should the headset connector become dirty, a scratchy or
intermittent signal may be experienced. To clean the connector,
dip the non-padded end of either a wooden or paper handled
cotton swab in isopropyl alcohol. Gently insert in the connector
and twist, repeating several times. If available, blow
compressed air into the connector to clear debris.
21-300632, Issue 1, July 2005 Page 30