beautypg.com

Stuart Turner 12/50 12 V User Manual

Page 10

background image

- 10 -

4. Replace new Brush Assembly by fitting

the carbon head into the retaining slot

as

shown.

Note: the Brass Cap of the assembly

also fits into this retaining slot - see

section

5.

Cont ...

5. Push the Brush Retaining Cap against

the spring tension and screw firmly into

place until tight, noting that the Brass

Cap of the assembly is correctly located

in the retaining slot as shown in

section

4.

Note:

DO NOT OVERTIGHTEN

6. Repeat the process for the opposite site.

Cleaners, Disinfectants and Descalents

On installations where chemical disinfectants or descalents are periodically

used, the compatibility of the chemical solution regarding the pump must be
considered.

Acid based descalents and aggressive cleaning agents must not come into

contact with the pump. The pump must be removed from the system prior to the
use of these products. The system should be flushed to remove all chemicals
before the pump is re-connected.

If in any doubt as to the suitability of the chemical solutions, please contact

our Pump Assist helpline.

STORAGE

If this product is not installed immediately on receipt, store in a dry, frost and vibration

free location in its original packaging.

Fig. 8

Fig. 7

Brass Cap

Retaining
Slot

Carbon
Head

This manual is related to the following products: