beautypg.com

Front panel indicators, Rs232 remote control, 12v trigger input – Arcam MULTI ZONE POWER AMPLIFIER MZ8 User Manual

Page 11: Troubleshooting

background image

11

Front panel indicators

The front panel Zone Status LEDs indicate the status of each of the

amplifier zones:

• Red - standby
• Amber - zone muted
• Green - zone on
• Flashing Red - over temperature

RS232 remote control

The Arcam MZ amplifiers may be remote controlled using an RS232

data connection. The communication protocol is described from page 13

onwards. The following functions are available:

• Zone mute on/off
• Power/Standby
• Query zone status (mute, temperature)

12V Trigger Input

If a 12V trigger output is provided by any of the pre-amps connected to

the MZ amplifier, it can be connected to the 12V trigger in socket using a

3.5mm jack (shown below).
This enables the MZ amplifier to be powered on or off remotely from a

pre-amp.
Note that the main power switch on the front panel must be depressed

to allow the MZ amplifier to be switched in and out of standby using this

method.

Troubleshooting

If you are having trouble with your amplifier, check the following items:

no sound
Check the following:

• Both the source component (pre-amp) and MZ amplifier are

switched on, indicated by the front panel LED being lit green on the

MZ amplifier.

• The MZ amplifier is not in standby, indicated by the front panel LED

being lit red.

• The source component (pre-amp) is not muted.
• The MZ amplifier is not muted, indicated by the front panel LED

being lit amber.

sound cuts-out unexpectedly

or suddenly becomes poor or distorted:
If the temperature of the internal heatsink rises above a safe level, then

a thermal cut-out inside the amplifier will operate. During this time

the front panel LED will flash red and the amplifier protection system

temporarily removes the power to the speakers. The system will reset

itself as the heatsink cools down.

• With low-impedance speakers connected (6Ω or less), overloads are

more likely.

• Overloading the amplifier may cause it to shut down because of

overheating.

Screen = Ground
Tip = +12V trigger signal

3.5mm jack - trigger connections

This manual is related to the following products: