Set up – MAHLE RTI MCX-2 (Rev F) User Manual
Page 5
Page 4
New Coolant Tank
Coupler
Quick
Green Hose
OF
F
OF
F
OFF
TES
T
SYS
TEM
VAC
UU
M
SYS
TEM
PR
ESS
URE
FILL
RA
DIA
TOR
& O
VE
RFL
OW
EXC
HA
NG
E C
OO
LAN
T
EM
PTY
WA
STE
TAN
K
LOW
ER
RA
DIA
TOR
& O
VER
FLO
W
& O
VER
FLO
W
LO
WER
RA
DIA
TOR
EXC
HA
NG
E C
OO
LAN
T O
R
FILL
RA
DIA
TOR
& O
VER
FLO
W
EM
PTY
W
AST
E TA
NK
Green Hose
Black Hose
Tank Cap & Plug
(Small)
New Coolant
SET UP
Install Filter and Bowl on rear of MCX-2 as shown. These
items are shipped in the carton with the adapters and
adapter hoses.
The MCX-2 has two tanks (plus an extra New Coolant Tank) which are installed and
connected from the rear. Quick connect couplers are mounted on the hoses which
connect these tanks to the MCX-2. A green hose connects to the small New Coolant
Tank and a black hose connects to the large Waste Tank. The small diameter black
drain hose must be inserted into the hole in the cap of the Waste Tank.
1. Slide the New Coolant Tank to the
rear and sit it on the floor.
2. Remove the tank cap and fill the
tank with new coolant and water in
the proportions specified by the
coolant supplier. The tank can be
disconnected and moved to a bulk
coolant storage area for filling if
desired. A plug is provided on the
cap to prevent spillage during
transport.
3. Replace the tank cap and position
the tank in the MCX-2. Make sure
the green hose is securely
connected. Slide the tank to the
front so the liquid level can be
seen through the front panel slot.
4. Make sure the plugs are removed from the caps on the Waste Tank and
the New Coolant Tank. This is required for venting the tanks during
operation. The small diameter black drain hose must be inserted into the
hole in the cap of the Waste Tank.
5. Fasten the clips on the tank strap to secure the tanks in the MCX-2.