MAHLE RTI MCX-2 (Rev D) - Manual (Page 17)

Page 16
Bulk Waste Container
FILL RA DIA TOR & O VER F LO W
LO WER RA DIA TO R & O VER FLO W TES T EMP TY W AST E TA NK
OFF
EM PTY WA STE TA NK
OF F
EXC HA NGE CO OLA NT
EXC HAN GE CO OLA NT O R
FIL L R ADIA T OR & O VER FLO W
OF F
Black Hose
SYS TEM VAC UUM
SYS TEM PR ESS URE
& O VER FLO W
LOW ER R ADIA TOR
Green Hose
FILL RA DIA TOR
& O VER
FLO W
EXC
HAN
GE C
OO LAN
T O R
EMP
TY W
AST
E TA NK
& O VER FLO W
LOW
ER R
ADIA
TOR
EM PTY W AST E T ANK
TES T
EXC
HAN
GE C
OO LAN T & O VER FLO
W
FILL RA DIA TOR
OFF
OFF
SYS TEM
PR ESS URE
SYS TEM
VA CUU
M
OFF
LOW
ER R
ADIA
TOR
& O VER
FLO W
EMPTYING THE WASTE TANK
The Waste Tank can be emptied two different ways.
A. The Waste Tank can be removed from the MCX-2 and transported to the area
where it is to be emptied. A quick connect coupler is installed on the black hose
to make this disconnection quick and clean.
B. The MCX-2 can be used to pump the waste coolant directly from the Waste
Tank into another waste collection tank. A 12 volt battery will be required to
power the MCX-2.
1. Install the Wand on the black hose.
2. Turn the control valve to EMPTY WASTE TANK.
3. Press the top of the EMPTY WASTE TANK selector switch to start the pump.
4. Hold the Wand over the Bulk Waste Container and open the valve.
5. Waste coolant will be pumped directly from the MCX-2 Waste Tank into the
Bulk Waste Container.
6. Close the valve on the Wand when done.
7. Press the bottom of the EMPTY WASTE TANK selector switch to stop the
pump.