Set up, Page 4 – MAHLE RTI MCX-2 (Rev C) User Manual
Page 5
Page 4
New Coolant Tank
Coupler
Quick
Green Hose
OF
F
O FF
OF
F
TES
T
SY
ST
E M
VA
C U
UM
SYS
TE M
P
R ES
SU
RE
FI L
L R
AD
IAT
O R
& O
VE
RFL
OW
EX
C HA
NG
E C
OO
LAN
T
EM
PTY
W
AS
TE
TA
NK
LO
WE
R R
AD
IAT
O R
& O
VE
RF
LO
W
& O
VE
RFL
OW
LO
WE
R R
AD
IAT
OR
EX
CH
AN
GE
C
OO
L A
NT
O
R
FILL
RA
D IA
TO
R &
O
VER
FLO
W
EM
PT
Y W
AST
E T
AN
K
Green Hose
Black Hose
Tank Cap & Plug
(Small)
New Coolant
SET UP
Install Filter and Bowl on rear of MCX-2 as shown. These
items are shipped in the carton with the adapters and
adapter hoses.
The MCX-2 has two tanks (plus an extra New Coolant Tank) which are installed and
connected from the rear. Quick connect couplers are mounted on the hoses which
connect these tanks to the MCX-2. A green hose connects to the small New Coolant
Tank and a black hose connects to the large Waste Tank. The small diameter black
drain hose must be inserted into the hole in the cap of the Waste Tank.
1.
Slide the New Coolant Tank to the rear
and sit it on the floor.
2.
Remove the tank cap and fill the tank
with new coolant and water in the
proportions specified by the coolant
supplier. The tank can be disconnected
and moved to a bulk coolant storage
area for filling if desired. A plug is
provided on the cap to prevent spillage
during transport.
3.
Replace the tank cap and position the
tank in the MCX-2. Make sure the
green hose is securely connected.
Slide the tank to the front so the liquid
level can be seen through the front
panel slot.
4.
Make sure the plugs are removed from the caps on the Waste Tank and
the New Coolant Tank. This is required for venting the tanks during
operation. The small diameter black drain hose must be inserted into the
hole in the cap of the Waste Tank.
5.
Fasten the clips on the tank strap to secure the tanks in the MCX-2.