MAHLE RTI MCX-1 (Rev A) - Manual (Page 10)

Page 9
ON
LO W ER RAD IAT OR & O VE RF LO W ON
ON
EXC HA NGE CO OLA NT FIL L RA DIAT OR & O VER FL O W OF F ON EMP TY WA ST E TA NK OFF
OF F
ON
WA STE EMP TY
DRA IN
FILL
OF F
OF F BL A CK
OF F
BLA CK
GRE EN OF F GRE E N
BLA CK
OFF
BLA CK
ON
LOW ER R ADIA TOR & O VER FLO W
ON
ON
EXC HAN GE CO OLA NT FILL RA DIA TO R & OV ERF LOW
OFF
ON
EM PTY W AST E TA NK
OFF
OFF
ON
WA
STE
EM
PTY
FILL
DRA
IN
OFF
BLA CK
BLA CK
GR EEN
OFF
OFF
GR EEN
Green Hose
Heater Block
Wand
Radiator
Overflow
Pump
Water
Core
Black Hose
Hose
Radiator
Engine
COMPLETING THE JOB
All used coolant in the vehicle cooling system has now been replaced with new
coolant. The following steps will complete the job.
1. Close the valves on the Step Adapters.
2. Disconnect the black and green hoses from the Step Adapters.
3. Install Wand on black hose. Close the valve.
4. Remove the cap from the radiator.
5. Press top of DRAIN selector switch to turn on pump.
6. Use the Wand to lower the level of coolant in the radiator to a level just below
the upper hose where the Step Adapter is attached. Open valve on Wand as
required.
Continued on next page . . .