Pro-Cut PFM 9.2 - Manual (Page 12)

Perfect brake job. Every time.
PFM 9.0 / 9.2 DRO SAFETY MANUAL
• They are intended to be used with professionally installed vehicle hoists.
• They are intended to be used only in combination with the supplied trolley.
• They are intended to be used only in repair shops with concrete or other flat flooring.
• They are not designed for outdoor use.
• They are not intended to be cleaned by water or air spray, only through direct
mechanical action, such as a brush, rag or broom.
• They are intended to be used in environments with good ambient or task lighting, not
less than 200 lux.
• Any use for other purposes is specifically disallowed.
ELECTRICAL REQUIREMENTS:
• Single Phase, 220-240 Volts AC, 50 or 60 Hz
• Earth Grounded Power (wall) Outlet Required
SUITABLE PERSONNEL:
• Pro-Cut on-car lathes are intended to be used only in a professional automotive
repair facility.
• They are intended to be used only by trained automotive repair technicians, who have
been specifically trained in disc brake service.
REQUIRED INDIVIDUAL SAFETY EQUIPMENT:
• Safety Glasses
• Close fitting overalls or mechanic’s work clothing
• Hair nets or caps to hold long hair
10 TECHNOLOGY DRIVE #4, W. LEBANON, NH 03784 USA P. 800.543.6618 / 603.298.5200 FAX. 603.298.8404 [email protected] WWW.PROCUTUSA.COM 12 10 TECHNOLOGY DRIVE #4, W. LEBANON, NH 03784 USA P. 800.543.6618 / 603.298.5200 FAX. 603.298.8404 [email protected] WWW.PROCUTUSA.COM