Yokogawa EJX438B User Manual
User’s manual
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- 1. Introduction
- 2. Handling Cautions
- 2.1 Model and Specifications Check
- 2.2 Unpacking
- 2.3 Storage
- 2.4 Selecting the Installation Location
- 2.5 Pressure Connection
- 2.6 Restrictions on Use of Radio Transceivers
- 2.7 Insulation Resistance and Dielectric Strength Test
- 2.8 Installation of an Explosion-Protected Instrument
- 2.9 EMC Conformity Standards
- 2.10 Pressure Equipment Directive (PED)
- 2.11 Low Voltage Directive
- 2.12 Regulatory Compliance for Radio and Telecommunication
- 3. Component Names
- 4. Installation
- 5. Wiring
- 6. Operation
- 7. Setting Parameters
- 7.1 Environment for parameter setting
- 7.2 Preparing Software
- 7.3 Setting Parameters
- 7.3.1 Parameter Usage and Selection
- 7.3.2 Function Block and Menu Tree
- 7.3.3 Parameters for Wireless Communication
- 7.3.4 Tag and Device Information
- 7.3.5 Unit
- 7.3.6 Range Change
- 7.3.7 Output Mode
- 7.3.8 Output Signal Low Cut Mode Setup
- 7.3.9 Impulse Line Connection Orientation Setup
- 7.3.10 Integral Indicator Display Mode
- 7.3.11 Integral Indicator Scale Setup
- 7.3.12 Unit for Displayed Temperature
- 7.3.13 Unit for Displayed Static Pressure
- 7.3.14 Zero Point Adjustment and Span Adjustment
- 7.3.15 Software Write Protect
- 7.3.16 Switching to Deep Sleep Mode
- 7.3.17 Switching to Silence Mode
- 7.4 Self-Diagnostics
- 8. Maintenance
- 9. Parameter Summary
- 10. General Specifications
- Revision Information