Yokogawa EJX438B - Manual (Page 7)

<1. Introduction>
1-3
IM 01C27H01-01EN
1.2 Radio Wave
IMPORTANT
- This instrument is equipped with a wireless
module which is designated as a certification
of construction type as a wireless
facility for 2.4 GHz band low-power data
communication system of the Radio Act.
Refer to 2.12 “Regulatory Compliance for
Radio and Telecommunication” for detail.
- Due to the designated certification of
construction type, users may be subject to
legal punishment in case of:
- Disassembling or modifying the wireless
module or antenna in this instrument
- Peeling off the certification label attached
to the wireless module in this instrument
- Preventing interference with other wireless
stations
The operating frequency bandwidth of this
instrument may overlap the same range
as industrial devices, scientific devices,
medical devices, microwave ovens, licensed
premises radio stations and non-licensed
specified low-power radio stations for mobile
object identification systems used in factory
production lines.
Before using this instrument, ensure that
neither a premises radio station nor specified
low power radio station for mobile object
identification systems is in use nearby.
If this instrument causes radio wave
interference to a wireless station for mobile
object identification systems, promptly
change the frequency being used or turn
off the source of radio wave emissions.
Then, contact a Yokogawa office regarding
countermeasures to prevent interference,
such as setting up partitions.
1.3 Warranty
• The warranty shall cover the period noted on
the quotation presented to the purchaser at the
time of purchase. Problems occurring during
the warranty period shall basically be repaired
free of charge.
• If any problems are experienced with this
instrument, the customer should contact the
Yokogawa representative from which this
instrument was purchased or the nearest
Yokogawa office.
• If a problem arises with this instrument,
please inform us of the nature of the problem
and the circumstances under which it
developed, including the model specification
and serial number. Any diagrams, data and
other information you can include in your
communication will also be helpful.
• The party responsible for the cost of fixing the
problem shall be determined by Yokogawa
following an investigation conducted by
Yokogawa.
• The purchaser shall bear the responsibility for
repair costs, even during the warranty period, if
the malfunction is due to:
- Improper and/or inadequate maintenance by
the purchaser.
- Malfunction or damage due to a failure
to handle, use, or store the instrument in
accordance with the design specifications.
- Use of the product in question in a location
not conforming to the standards specified by
Yokogawa, or due to improper maintenance
of the installation location.
- Failure or damage due to modification or
repair by any party except Yokogawa or an
approved representative of Yokogawa.
- Malfunction or damage from improper
relocation of the product in question after
delivery.
- Reason of force majeure such as fires,
earthquakes, storms/floods, thunder/
lightening, or other natural disasters, or
disturbances, riots, warfare, or radioactive
contamination.
1.4 Trademarks
In this document, trademarks or registered
trademarks are not marked with “™” or “®”.
Product names and company names in this
document are trademarks or registered trademarks
of the respective companies