Yokogawa YFGW710 - Manual (Page 7)

7
IM 01W01F01-11EN
n Notes on Attached Software
l Before opening the media package, read YFGW710 Software License Agree-
ment. Once the package is opened, it is thought that the contract is agreed.
l Yokogawa assumes no responsibilities for this software except as stated in
the warranty.
l This software is used with this product exclusively. This can be installed in the
computer which connects with this product.
n Insulation Resistance and Dielectric Strength Test
l Insulation Resistance and dielectric strength test could not be carried out
for YFGW710, due to the circuit ground is connected directly to the frame of
YFGW710 via RF cable shield.
n Cautions for Safely Applying the Device
l EMC Conformity Standards
EN61326-1 Class A, Table 2 (For use in industrial locations), EN61000-6-2
CAUTION
This instrument is a Class A product, and it is designed for use in the industrial environment.
Please use this instrument in the industrial environment only.
l R&TTE Conformity Standards:
ETSI EN 300 328, ETSI EN 301 489-17, EN61010-1, EN62311
• Indoor/Outdoor use
l Low Voltage Directive
Applicable standard: EN61010-1
(1) Pollution Degree 2
“Pollution degree” describes the degree to which a solid, liquid, or gas which deteriorates dielec-
tric strength or surface resistivity is adhering. “2” applies to normal indoor atmosphere. Normally,
only non-conductive pollution occurs. Occasionally, however, temporary conductivity caused by
condensation must be expected.
(2) Installation Category I
“Overvoltage category (Installation category)” describes a number which defines a transient over-
voltage condition. It implies the regulation for impulse withstand voltage.
“I” applies to electrical equipment which is supplied from the circuit when appropriate transient
overvoltage control means (interface) are provided.