AEG KO-LAVAMAT 88830 - Manual (Page 49)

Setting up and connection instructions
49
Electrical Connection
Refer to the rating plate for details
of the mains voltage, current type
and the necessary fuses. The rating
plate is located at the top behind
the filling door.
; This unit conforms to the following
EU directives:
– the ”Low Voltage Directive" 73/23/EU with changes
– the ”EMC Directive" 89/336/EWG with changes
Water Connection
3 The washing machine has safety features which prevent contamination
of the drinking water and which conform to the legal regulations of
the water authorities (e.g. for Germany: DVGW regulations). Other pro-
tection measures in the installation are therefore not necessary.
Attention!
– Units for connection to cold water must not be connected to hot
water!
– Use only new sets of hoses for connection!
Permissible Water Pressure
The water pressure must be at least 1bar (= 10N/cm
2
= 0.1MPa), maxi-
mum 10bar (= 100N/cm
2
= 1MPa).
• In the case of more than 10bar: Connect a pressure-reducing valve
upstream.
• In the case of less than 1bar: Unscrew the intake hose on the unit
side on the inlet solenoid valve and remove the flow regulator (to do
this, remove the filter with pointed pliers and remove the rubber
washer behind). Replace the filter.