AEG KO-LAVAMAT 88830 - Manual (Page 48)

Setting up and connection instructions
48
Compensate for Floor Unevenness
3 Automatic Adjustment Foot: Your washing machine's rear left foot is
of a spring leg design. This guarantees good stability of the unit, even
at high spinning speeds.
If the washing machine still does not stand firmly enough during spin-
ning, proceed as follows:
0 1. Adjust the three adjustment feet
to the setpoint 10mm. To do this,
use the supplied special button to
remove the transport safeguard.
If the automatic adjustment foot
still does not reach the floor:
2. Manually extend the automatic
adjustment foot (rear left) by the
necessary amount.
3. If necessary, check the setting
with a spirit level.
Attention! Never use wood, card
or similar underlays to compen-
sate for minor floor unevenness. Always use the adjustable screw-type
feet of the machine.