The washing cycle is finished/remove the washing – AEG KO-LAVAMAT 88830 User Manual
Page 26
Instructions for use
26
Abort program
0
Turn the program selector to OFF (ARRET) to abort the washing
program.
3
The washing program can be interrupted at any time by pressing the
START/PAUSE (MARCHE/PAUSE) button and then continued by pressing
it again.
The washing cycle is finished/Remove the washing.
END (FIN) is lit at the program sequence display when a washing
program is finished.
3
The washing machine switches itself into the stand-by mode if no
button is pressed or the program selector is not turned within approx.
3 minutes after the end of the program. Only END (FIN) is illuminated.
All other displays on the control panel are switched off in order to save
energy. Pressing any arbitrary button cancels the stand-by mode.
• A crease protection phase of approx. 30 minutes follows at the end of
the program if program EASY IRON (SANS REPASSAGE) had been
selected. The multidisplay also shows the remaining time and the
display END (FIN) is illuminated. You can open the filling door and
take the washing out at any time during the crease protection phase.
• START/PAUSE (MARCHE/PAUSE) flashes if spin speed 0 (rinse hold )
was selected.
0
1. After a rinse hold it is first of all necessary to pump off the water:
– Either press START/PAUSE (MARCHE/PAUSE) button (the washing will
be spun according to the just finished program; with the SPIN SPEED
(VITESSE D´ESSORAGE) button the spin speed can be changed even
during the spin-drying process), or
– turn program selector to PUMP (VIDANGE) and then press START/
PAUSE (MARCHE/PAUSE) button (the water is pumped off without a
spin), or
– Turn the program selector to SPIN (ESSORAGE) or to SHORT SPIN
(ESSORAGE DELICAT) and press START/PAUSE (MARCHE/PAUSE)
button (the washing is spin-dried normally or with a short spin).
END (FIN) is illuminated at the end of this program step.
2. Open the filling door.
As soon as DOOR/LIGHT (PORTE/LUMIERE) is illuminated in green the
door can be opened (not if program saving is active, see "Program Sav-
ing").
3. Remove the washing.