AEG KO-LAVAMAT 88830 - Manual (Page 34)

Instructions for use
34
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The height-adjustable screw
feet are not correctly set.
Adjust in accordance with
the installation and connec-
tion instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped off before
spinning because
the drainage hose is bent or
the solution pump is blocked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump
housing.
The washing solution
of the main wash
froths up a lot.
Probably too much detergent
was used.
Meter the detergent exactly
in accordance with the man-
ufacturer's information.
Water is flowing out
from beneath the
washing machine .
The screw connection on the
intake hose is leaky. Tighten the intake hose
screw connection.
The drainage hose is leaky.
Check the drainage hose and
replace it if necessary.
The washing solution pump
cover is not correctly closed.
Close cover correctly.
Washing in caught in the
filling door.
Abort the program, remove
washing from the door and
start a new program.
The emergency drain hose is
not properly shut off or it is
not water-tight.
Shut the emergency drain
hose off properly (see section
"Performing an Emergency
Drain"). Call your after-sales
service if the emergency
drain hose is not water-tight.
Problem Possible Cause Remedy