Yokogawa AXFA14G/C - Manual (Page 20)

IM 1E6K2-E
4-19-12
4. OPERATION
Cover without GLASS GLASS:3mm
Place the amplifier unit in the junction box.
Connect to Host
Proceed to 4.9.2 Checking Procedure.
• Only the amplifier is housed in the junction box.
(1) Insert the connector pins of the amplifier into the two connectors on the terminal
board of the junction box, aligning the holes of the plate with the positioning pins as
shown in the figure.
(2) Engage the connectors to the amplifier. (See Figure 4.9.7.)
(3) After checking that the connections are secure, firmly tighten the fixing three screws.
(4) Screw in the cover firmly as shown in Figure 4.9.7.
• Connect junction box terminals FB+, FB- to the host.
Figure 4.9.7 Setting Converter Unit in Junction Box