Yokogawa AXFA14G/C - Manual (Page 2)

IM 1E6K2-E
2-1-1
2. HANDLING PRECAUTIONS AND REQUISITES
2. HANDLING PRECAUTIONS
AND REQUISITES
The Model AM012 Magnetic Flowmeter Calibrator is thoroughly tested at the factory
before shipment. However, when the instrument is delivered, make a visual check to
ascertain that no damage occurred during shipment.
This section describes important precautions and requisites to be observed when
handling the instrument. Carefully read this manual before using the instrument.
If there are any problems or questions, please contact the nearest YOKOGAWA
service center or the dealer from whom the instrument was purchased.
2.1 Model Name and Specifications
The Model name and main data are indicated on the name plate attached at the rear of
the case (see Figure 2.1).
CALIBRATOR
MODEL
*A
SUPPLY
NO.
180 — 264V AC at 200V series
AM012-
90-132VAC
47-63Hz
Made in
Figure 2.1 Data Plate
Verify that the data are the same as those specified at the time when it was ordered,
referring to the Model and Suffix Codes in Section 3.2.
When contacting us, please indicate the Model and the instrument serial number.
2.2 Handling and Storing Precautions and Requisites
Precautions and requisites to be taken when handling and storing this instrument:
(1) Prevent excessive shock to the instrument.
(2) Protect the instrument from water and precipitation.
(3) Calibrate the instrument at normal temperature and humidity.
(4) Avoid installation or storage of the instrument in a corrosive atmosphere.
(5) Store the instrument in a location:
• free from water and precipitation.
• relatively free from vibration and shock.
• where the ambient temperature is between 0
°
C and 40
°
C and the humidity is
between 5% and 80% relative humidity (well-ventilated and without condensation).