Wright Serial # 69788 and Higher - Manual (Page 29)

29
WARNING
6.12 Fuel Evaporation System
All Wright Stander I ’s need to have this mandatory feature.

Do Not alter or remove.
 Do Not fill past the “Max Fill Level” line.

Over-filling could result in clogging the roll-over vent and/or contaminating the purge
canister.

The vapor canister is located under the dash.

Inspect and clean dust filter every 500 hrs or annually.
6.13 Spindle Pulley Split hub R&R
 Remove 2, ¼” bolts from split hub and install in threaded holes in hub.

Slowly tighten each bolt, alternating as you tighten bolts against the pulley.

The hub will separate from the pulley.

Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley and spindle
shaft.
Dust Filter
Vent /
Purge
To
Tank
Assembly
hole
Threaded
Removal
holes
Assembly
hole
Tightening will
separate the hub
from the pulley