Wright Serial # 69788 and Higher - Manual (Page 11)

11
WARNING
WARNING
 Before attempting to start the engine, follow all starting instructions below and in the engine operator’s
manual.

Look behind before backing up.
 Before leaving the operator’s position, even momentarily, turn off the blade clutch engagement switch and
apply the parking brake. Keep others from coming near the mower. Get back on the mower as soon as
possible.

When leaving the Wright mower unattended, turn off the blade clutch engagement switch, apply the
parking brake, stop the engine and remove the key. Never leave the machine unattended on a slope in
case someone disengages the parking brake. This could create a rollover hazard.

When transporting, driving onto transport vehicles, into buildings, across parking lots or otherwise not
mowing grass, turn off the blade clutch engagement switch to reduce risk of thrown objects and rotating
blade hazard. After coming to a stop apply the parking brake, stop the engine and remove the key.

Before performing any maintenance or repair service, disengage power to blades, apply the parking brake,
stop the engine, remove ignition key and spark plug wire from spark plug(s).

All operators of this mower should exercise caution when driving this mower at high speeds. Sudden
acceleration or deceleration may cause serious injury.

Do not allow inexperienced persons to operate the mower until they have read and understood these
safety instructions. Operate the mower at slower speeds while becoming familiar with it.

The grass discharge chute deflector must be installed at all times and in the down position except that it
may be raised when cleaning out the deck or a grass catcher is installed or a mulch kit and block-off plate
is properly installed.

If the mower discharges grass clogs, turn off the blade clutch switch, apply the parking brake, stop the
engine and remove the key before removing obstruction(s).

Keep all shields and covers in place, namely, all blade and belt covers, engine shields, and grass
discharge chute deflector.

Keep hands, feet and clothing away from rotating parts, especially the rear wheels, blades, engine
flywheel, belts and pulleys.

Do not touch engine, muffler or hydraulic system while engine is running or soon after it is stopped. These
areas can be so hot as to cause severe burns.

Clean grass, leaves and lubricant spills from surfaces after use to prevent fire hazard.

Be alert for traffic when crossing roads or operating near roadways.

Before climbing curbs, crossing gravel drives, sidewalks or roads, turn off the blades and wait for them to
stop.
1.13 Safety for Maintenance

Repairs carried out by untrained or unauthorized personnel may result in personal injury or serious
malfunction of the Stander Intensity.

If Guarding is removed for inspection and component replacement, ensure the parking brake is applied
and key is removed prior to inspecting or making repairs and that the guarding is replaced before
operation.
1.14 Operation in Forward Direction
Always keep a firm grip on the mower stationary handlebar with both hands. Operate the mower slowly
until you become familiar with how the mower operates. Do not operate the mower faster than conditions
allow. For example, hills, wet or bumpy ground, dim light or high grass are all conditions requiring slower
speeds. Never operate the mower at the highest speed unless you are on level, wide, open areas of clearly
visible ground or transporting on paved areas. Speeding with any mower is dangerous, and so is traveling
faster than conditions should permit on this mower. Sudden stops from excessive speed or falling off the
mower may cause serious injury or death.