Pfister GT531-YPY - Manual (Page 5)

E
N
G
L
IS
H
ENGLISH
ENGLISH
MAINTENANCE & CARE
18
17
16 19
20
16 PULL-OUT OPERATION
The Spray Head (16A) can be pulled forward to spray water in any direction.
17 SPRAY OPERATION
To activate the spray mode, simply press Toggle Button (17A) located under the spray
head. You can change between spray and stream by pressing the opposite sides of the
Toggle Button (17A/17B) while the faucet is in operation. The water fl ow will increase by
sliding Spray Selector Switch (17C) from side to side (in spray mode only).
Note: The faucet will always turn on in regular stream mode.
18 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may have
collected in the water lines, it will be necessary to fl ush the faucet. Flushing requires
the removal of the Spray Head (18A). To remove the Spray Head (18A), hold metal
Hose Fitting (18B) and turn the Spray Head (18A) counterclockwise. Turn the Valve
Lever Handles (18C) to the full on position. Run water for one minute. Repeat in hot
and cold positions. Reassemble the Spray Head (18A) to the Pull-Out Hose (18D) by
turning Spray Head (18A) clockwise.
Caution: do not over tighten spray head and pull-out hose.
19 AERATOR CLEANING
Over time, the aerator in your faucet may become clogged with debris. To clean the
aerator, unscrew Aerator Housing (19A) from Spray Head (19B). Remove Aerator Seal
(19C) and Aerator Cartridge (19D) from Aerator Housing (19A). Clean Aerator Cartridge
(19D) and Aerator Housing (19A). Reassemble faucet by reversing steps.
20 HOSE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet. To
remove Pull-Out Hose (20A), Push up on Quick Connector (20C). Holding Plastic Collet
(20D) in place, pull downward on Quick Connector (20C) until Tube (20E) is free. To
detach Hose Assembly (20B), remove Clips (20H) from End Valve (20F) and pull the
End Connectors (20G) from End Valves (20F).
5
19D
20A
17A
16A
18A
17B
17C
18B
18C
18C
18D
19A
19C
19B
20C
20D
20E
20B
20E
20E
20F
20F
20G
20G