Pfister VTP-E11WE - Manual (Page 4)

EN
G
LI
SH
ENGLISH
14
15
11
16
10
11 WATER SUPPLY CONNECTION
Use FTFE plumbers tape on threaded fittings according to manufacturer’s instructions.
For E10W models:Attach Large Hose Nut (11C) to Fill Valve Shank (11D) located on rear
of Toilet Bowl. Connect Short Hose Nut (11A) onto Water Supply Valve (11B). Turn on
Water Supply Valve (11B) by turning Handle (11E) counterclockwise. For E11W models
only, connect Short Hose Nut (11A) onto Water Supply Valve (11B).
12 INTERNAL PLUMBING
Tank comes pre-installed with flushing mechanism.
13 UNIT START UP
Turn on Main Water Supply Valve and check for leaks.
14 TANK LID INSTALLATION
Place Tank Lid (14A) on top of Tank (14B). Be sure Lid Lip (14C) covers the top of
Tank (14B).
15 FLUSHING
Press Flush Button (15A) to activate flushing mechanism. Flushing Button (15A) comes
with Full Flush (15B) and Reduced Flush (15C). Check for leaks above and below the
toilet.
16 SECURING TOILET BOWL
Secure Toilet Bowl (16A) to the floor surface by placing a bead of sealant around Toilet
Bowl Base (16B). (Sealant not included). Please follow manufacturer’s instructions
when using sealant.
10 TOILET BOWL INSTALLATION
A. Carefully set Toilet Bowl (10A) over Outlet Connector (10B) aligning the Bowl Outlet
Hole (10C) with Outlet Connector Hole (10D).
B. Place Plastic Washer (10E) and Screw (10F) into Hole (10G) located on the base of
Toilet Bowl. Secure by Tightening Screw (10F) until Toilet Bowl (10A) adheres to the
bracket inside fixture. Place Decorative Cap (10H) over Plastic Washer (10E) as shown.
4
14A
14B
14C
15A
15B
15C
11E
11B
11A
11C
11D
16A
16B
10A
10B
10C
10C
10D
10G
10E
10H
10F
10D
A
B