En g li sh – Pfister VTP-E11WE User Manual

Page 2

ENGLISH

Thank you for purchasing this Price Pfister product. All Price Pfister products

are carefully engineered, and factory tested to provide long trouble-free use

under normal conditions. This product is easy to install using basic tools and

our easy to follow illustrated instructions.

3 TOOLS RECOMMENDED

• FTFE Plumber’s Tape

• Spatula

• Safety Goggles

• Sealant

• Slotted screwdriver

• Phillips Screwdriver

• Pliers

• Adjustable wrench

• Flashlight

• Cloth

Your installation may require other additional tools.

4 CONTENTS OF THE BOX

A Seat Cover

B Outlet Connector

C Wax Ring

D Toilet Bowl

E Toilet Tank (for E11W only)

F Toilet Lid

G Installation Kit: {Supply Valve, Flange, Hose, Rubber Gasket, [Tee Bolts (2), Nuts (2),

Washers (2)], [Brass Bolts (2), Brass Nuts (2)], [Toilet Screws (2), Plastic Washer (2),

Decorative Cap (2)], [Optional Screws (2), Optional Anchors (2), Optional Washers (4)]}

1 BEFORE PROCEEDING

WARNING: This product comes complete for installation. Read all the instructions

completely before proceeding. Price Pfister recommends calling a professional if you

are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes. This product is heavy and fragile; use extreme care with all parts!

2 SHUT OFF WATER SUPPLY

Locate main water supply inlets and shut off the water supply valves. These are usually

found near the water meter. If you are replacing an existing toilet, remove the old toilet

and wax ring from the floor and clean the floor surface thoroughly.

For more information about the installation or care and warranty information,

please contact your local Black & Decker HHI representative in your country

or visit www.pricepfister.com/international.

For customers located in Canada

please contact Black & Decker, Canada Inc., Price Pfister Division, 100 Central Avenue,

Brockville, Ontario K6V 5W6, phone: 1-800-340-7608 (Canada only)

6 WATER SUPPLY VALVE INSTALLATION

A. Remove Sleeve (6A) and Cover Nut (6B) from Supply Valve (6C).

B. Slide Flange (6D) through Water Supply Pipe (6E) until it is tight to the wall. Insert

Supply Valve (6C) into Water Supply Pipe (6E) until the end of Pipe sits flush inside

Supply Valve (6C).

7 INSTALL NEW WAX SEAL

Place and align Tee Bolts (7A) into Flange Groves (7B) located on the Floor Flange

(7C) of Waste Outlet Hole as shown.

5 WORK AREA INSPECTION

Verify that the Waste Outlet Hole is 12” (305 mm) (5A) from the finished wall (5B).

E11W

E10W

This manual is related to the following products:

VTP-E11W