Pfister R89-7DFC - Manual (Page 4)

ENGLISH
ENGLISH
MAINTENANCE & CARE
13
12
14
15
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price
Pfister Consumer Service.
3. Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
13 TUB SPOUT FUNCTION
When the valve is turned on, water normaly flows through the Tub Spout (13A). To
activate the shower, turn valve on and pull the Knob (13B) up. Hold on until water flows
continiously from the shower arm.
11 UNIT START UP
Turn on hot and cold water supplies, and check all connections for leaks.
14 FINAL FLUSHING
For final flushing, turn valve on and allow water to run through the Tub Spout (14A) for
several minutes. Pull Spout Knob (14B) up to allow water to run through Shower Arm (14C).
Allow water to run for several minutes untill all foreign mater clears the line.
15 SHOWER HEAD INSTALLATION
Thread Shower Head (15A) onto Shower Arm (15B).
Make sure Shower Head (15A) is securely tightened to Shower Arm (15B).
12 VALVE FUNCTION
By rotating the Lever Handle (12A) slightly counterclockwise, the valve will be fully
activated to the “COLD” position. The water temperature can be increased by continuing
to rotate the Lever Handle (12A) in a counterclockwise direction.
4
FULL HOT
FULL COLD CLOSED
OPEN
UP
For
Shower
12A
15B
15A
13A
13B
14A
14B
14C