Pfister R89-7DFC - Manual (Page 2)

ENGLISH
ENGLISH
4
INSTALLATION STEPS
5
6
3
Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
WARNING: This product has been designed for use with the Price Pfister 0X8
series pressure balancing valve. It will not work with any other product.Please review
the 0X8 valve installation instructions before installing this product
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing unit, remove the old unit
and clean the mounting surface thoroughly.
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Philips head screwdriver • Adjustable wrench • Pipe wrench • Flashlight
• Cloth
Your installation will require a pipe nipple for the spout installation as well as other
additional tools.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Gasket & Trim Flange B Washer C Retainer Sleeve
D Stem Extension E Handle F Set Screw
G Hex Wrench H Diverter Spout J Shower Arm
K Shower Head L Shower Flange M Spout Flange
N Internal Connector
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
5 WORK AREA INSPECTION
Verify that the hole sizes and positions in the wall are correct.
6 PLASTERGUARD OPTIONS
A. For installation using plasterguard, knock out Center Section (6B) from Plasterguard
(6A). The use of plasteguard is optional for standard installations.
B. For installation without plasterguard, remove Screws (6C), and Plasterguard (6A).
2
L
B
C
D
E
F
G
N
H
K
M
J
A
6A
6B
6A
6C
30”
Tub & Shower
48”
Tub & Shower
8” Min.
30”
Shower Only
48”
Shower Only
1 1 /
4
” Dia.
4 3 /
4
” Dia.
4” Dia. for Thin
Wall Installation
1 1 /
4
” Dia.
A
B