English – Pfister GT49-DF0K User Manual

Page 3

ENGLISH

ENGLISH

7 VALVE FLANGE ATTACHMENT

Place Seal Base (7A) and Flange (7B) over Valve Body (7C) covering the Valve Body
Washers (7D). Secure by threading the Plastic Nut (7E) onto the Valve Body (7C).

8 HANDLE INSTALLATION

Screw Stem Extender (8A) onto the Valve Stem (8B). With Valves in “Closed” position,
attach Handle Hubs (8C) onto Valve Stems (8B) and tighten Set Screws (8D) with the
Hex Wrench that is provided. Make sure Set Screw (8D) is securely tightened to Handle
(8C). Attach Decorative Button (8E).

9 SPOUT ATTACHMENT

Insert Lift Rod (9A) into hole at the back of Spout (9B). Place Plastic Seal Base (9C)
against the bottom of Spout Base (9D). Place Spout Base (9D) against the bottom of
Spout Body (9E). With Spout (9F) facing forward, carefully install the Lift Rod (9A) and
Shank (9G) through the center hole of sink (9H).

10 SECURING SPOUT BODY

From underneath sink, secure Spout Body (10A) by placing Metal Washer (10B) and
threading Mounting Nut (10C) onto Spout Shank (10D). Make sure that the bumps on
Metal Washer (10B) are facing up. Make sure Lift Rod (10E) moves freely. Be sure
Spout Body (10A) is centered and facing forward and tighten the Mounting Nut (10C)
until Spout Body (10A) is ﬁrmly secured to sink.

Caution: Do not over tighten!

10A

10B

10C

10E

10D