Proface APL3000B - Node Box PC - Manual (Page 11)

11
Wiring
• Be sure to confirm that power is not
being supplied to the PS-B unit before
wiring . Failure to do so can result in an
electric shock.
• Any other power level can damage
both the PS-B and the power supply.
• Since the PS-B unit has no power ON/
OFF switch, be sure to attach a
breaker-type switch to its power cord.
• When the FG terminal is connected, be
sure the wire is grounded.
1. Wiring the power supply cable
• When the FG terminal is connected, be
sure the wire is grounded. Not
grounding the PS-B unit will result in
excessive noise. Use your country's
applicable standard for grounding.
„ Power Cord Specifications
Use copper conductors only.
„ Wiring
When connecting the power cord, use the
following items when performing wiring.
(Items are made by Phoenix Contact.)
• Accompanying DC type power supply
connector is CA7-DCCNL-01 from Pro-
face or GFKC2.5/3-STF-7.62 is manufac-
tured by Phoenix Contact.
„ Connecting the Power Cord
(1) Confirm that the power is not supplied to
the PS-B unit.
(2) Unplug the power connector from the
top of the PS-B unit.
(3) Push the Opening button with a small
and flat screw driver to open the desired
pin hole.
(4) Insert each pin terminal into its each
hole. Release the Opening button to
clamp the pin in place.
(5) After inserting all three pins, insert the
Power Plug into the Power Connector at
PS-B. Fix the plug with two (2) slot
screws.
Power Cord
Diameter
0.75 to 2.5mm
2
(18 to 12 AWG)
Conductor
Type
Simple or Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are
not twisted correctly, the end wires may either
short against each other, or against an
electrode.
Conductor
Length
10mm
Recommended
Driver
SZS 0.6x3.5 (1205053)
Recommended
Pin Terminals
AI 0.75-10GY (3201288)
AI 1-10RD (3200182)
AI 1.5-10BK (3200195)
AI 2.5-12BU (3200962)
Recommended
Pin Terminal
Crimp Tool
CRIMPFOX ZA3
(1201882)
24V
0V
FG
Opening Button
Power supply cord