Reelcraft Hose Reel Trailer - Manual (Page 4)

Hose Reel Trailer
Page 4 www.reelcraft.com
Figure 7
Assembly Instructions
The following instructions are for assembly of the
Hose Reel Trailer. Steps 2 through 5 are for
assembling accessories to the hose reel. Steps 6
through 11 are for the trailer and battery box
assembly.
Step 1:
Unpack and inspect all components for damage.
Note the way the hose pulls off of the reel in figure
7. The upper rollers are to be used on the side of
the reel that the hose pulls from the top of the spool.
The lower rollers are to be used on the side of the
reel that the hose pulls from beneath the spool.
Step 2:
Attach the chain guard to the reel as shown in figure
8. Use the 5/16-12 x 3/4” self tapping screws to
secure the chain guard to the reel. Turn the spool by
hand to check for interference. Adjust chain guard to
allow clearance from the chain drive.
Step 3:
Attach switch box to the reel in a convenient location
or as shown figure 8. Attach switch box to
mounting bracket (optional) using the 1/4-20
nuts and lock washers attached to switch box.
Recommended mounting hole size when not using
mounting bracket is 9/32” to 5/16”. When using
mounting bracket drill 11/32” to 3/8” holes.
Step 4:
Assemble and attach the lower roller assembly to
reel as shown in figures 6, 7 and 8. Use the 5/16-18
x 3/4” bolts and nuts supplied in the lower roller
bracket assembly.
Step 5:
Assemble and attach the upper roller assembly to
reel as shown in figure 5, 7 and 8. Use the 5/16-18
x 3/4” bolts and nuts supplied in the upper roller
bracket assembly.
Figure 8