Reelcraft Series TB/TBL Tool Balancers - Manual

TB 10 TB 12 TB 15 TB 23
TBL 10 TBL 12 TBL 15 TBL 23
Operating Instructions
Series TB / TBL Tool Balancers
Model Numbers:
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605
Customer Service: 855-634-9109 • [email protected] • www.reelcraft.com
Rev: 8/2013
Dimensions
DO NOT allow spring to unwind in an uncontrolled manner.
Doing so can result in damage to reel or personal injury.
DO NOT attempt to remove spring motor from its canister.
Doing so can result in damage to reel or personal injury.
WARNING
NOTE: To minimize wear on cable and cable guide, reel
should be mounted directly over work area and, preferably, on
a rolling trolley so that cable is pulled out as straight as pos-
sible during use.
MOUNT REEL
1. Use clevis to hang reel in desired location. Be sure cotter
pin is installed on clevis pin.
2. Attach optional safety chain to secondary hanger bracket
or other overhead support. Do not use the same attach-
ment point as used for the clevis. See figure 1.
CAUTION: To prevent reel fall should primary clevis mount
fail, it is recommended that a safety chain be used from reel
to a secure secondary support. Failure to use safety chain
could result in personal injury.
Figure 1
Safety Clip - 261241
Bright zinc plated steel cable and
safety latch for tool attachment and
other uses. Measures 2.375” (60 mm)
long. Included with each model.