Reelcraft Display Stand - Manual (Page 4)

Step 19:
Gather four of the end caps (#11) and at-
tach them to the ends of both of the front
legs (#4) and the back legs (#5) (see
figure 21).
Step 20:
Stand the display stand assembly upright.
Gather six of the cap screws (#12) and
slide three in each of the two cross bars
with access holes (#8) by sticking the
head of the cap screw (#12) into the ac-
cess hole then slide into position (see
figure 22).
Step 21:
Place the six display stand adapter plates
(#1) into position by sliding the bent end
over the top cross bars (#3) and aligning
the cap screw (#12) into the slot located
in the bottom of the display stand adapter
plate (#1) (see figures 23 and 24).
Step 22:
Gather six of the lock nuts (#13) and hand
tighten them to the cap screws (#12) to
hold the display stand adapter plate (#1) in
place (see figure 25).
Step 23:
Gather the four strips of graphic gasket
and slide two down into the top of the
upright (#2) in the slot facing the cross
bars, refer to Figure 26 for orientation.
Repeat for the other upright.
Add reels to display stand
To assemble a reel to the display stand
align the mounting holes of the reel with
the appropriate mounting hole pattern on
the display stand adapter plate (#1). At-
tach the reel using four cap screws (#12)
and four lock nuts (#13). The display
stand adapter plates can be adjusted to set
proper spacing on the display stand (see
figure 27).
Reelcraft Display Stand
Page 4 www.reelcraft.com
Figure 21
Figure 23
Figure 24
Figure 27
Figure 22
Figure 25
Figure 26