Rapid-Air DUAL SWIVEL REEL WITH DISPLAY KEYPAD: 100 & 1000 SERIES - Manual (Page 3)

1. The machine that you have just
received is fully assembled and
ready to be put into position. Due
to shipment vibration the machine
should be checked to be sure all
screws and bolts are tight.
Visually inspect the machine for
damaged parts due to shipment.
If the machine is damaged in
shipment, contact the carrier
first to report the damage, and
then Rapid-Air.
operating instructions
installation
The main control unit is located
behind the pushbutton cover.
Below is an illustration of the
layout of the control panel. This
diagram lists all the components
and the approximate location of
each that could be used for trouble-
shooting the machine if a problem
should occur. The reel is shipped
with – 120 VAC (1 phase) input.
Visually check all electrics before
starting the reel.
2. Install the machine on a level
surface with sufficient clearance
for loading and unloading coils.
3. The machine is completely self-
contained and need only be
plugged into a 20 amp, 120 volt,
60 HZ outlet. If an extension cord
is used as the source to the
machine, it should be a minimum
#12 wire to keep the voltage loss
down and for electrical safety
reasons.
CAUTION: DISCONNECT ELECTRICAL POWER
BEFORE PERFORMING ANY
SERVICE TO THIS MACHINE.