Ramsey Winch PATRIOT 15000 W/THERMAL PROTECTION - Manual (Page 4)

4
Installation
The winch shown in this owners manual is solely and
exclusively designed for vehicle mounted, non-industrial
applications. All other applications will void warranty.
It is very important that the winch be mounted on a flat
surface so that the three major sections (the motor end,
the cable drum, and the gear housing end) are properly
aligned. It is recommended that Ramsey kits be used to
mount the winch. They are designed to align the winch
and distribute up to the full rated load evenly, to avoid
possible damage to the winch or vehicle.
NOTE: If recommended mounting is not used, a kit of
equal design must be used.
Attach fairlead to channel using hardware furnished with
winch.
NOTE: To ensure proper alignment of roller fairlead to
winch, position larger (1/2”) holes at top.
Attach winch to channel. Thread capscrews with
lockwashers through mounting holes in channel and into
winch feet (see FIGURE 1).
Substitution of attaching hardware items (bolts, nuts or
washers) different from those supplied with your winch
and mounting kit can lead to failure causing damage or
serious injury (use SAE grade 5 bolts or better and
torque to 44 ft.lbs.).
IN THE TOP 1/2" DIA. HOLES OF FAIRLEAD
FAIRLEAD MOUNTING HARDWARE
TWO 7/16 LOCK WASHERS & TWO 7/16-14NC NUTS
TWO 7/16-14NC X 1.25 LG BOLTS
CLEVIS PIN
CABLE HOOK
OF VEHICLE BATTERY.
TO POSITIVE (+) TERMINAL
CONNECT RED CABLE
ROLLER FAIRLEAD
(CAUTION DECAL ON TOP)
CONNECT BLACK GROUND CABLE
TO NEGATIVE (-) TERMINAL
CONTROL SWITCH
RECEPTACLE
ROLL PIN
OF VEHICLE BATTERY.
FOUR 7/16 FLAT WASHERS
FOUR 7/16 LOCK WASHERS
WINCH MOUNTING HARDWARE
FOUR 7/16-14NC X 1.00 LG. BOLTS
MOUNTING CHANNEL
CLUTCH HANDLE
FIGURE 1