Ramsey Winch HD-234 (JERR-DAN) (NOT CURRENT) - Manual (Page 12)

10.Check cover bushing (item #15) for
signs of wear. If necessary remove old
bushing and press bushing into place.
11.Apply grease to end of shaft, oppo-
site gear. Apply grease to bushing
in gear housing (item #10). Place
greased end of shaft through thrust
washer (item #46) and bushing in
gear housing (item #10). Place
gasket (item #30) onto gear hous-
ing cover (item #6). Apply grease
to gear end of shaft and cover
bushing. Place cover onto shaft
and secure to housing with ten (item #18) capscrews. Tighten
capscrews to 8 ft. lbs. (10.8 Nm.) each.
12.Press bearing (item #14) onto worm (item #13). NOTE: Be sure
that thick shoulder of bearings outer race (side with manufactur-
er's name and part number) is out, away from worm threads.
Press bearing and worm into gear housing. Slip gasket (item
#29) onto bearing cap (item #4). Use four capscrews (item
#18) to secure cap to gear
housing. TIGHTEN CAPSCREWS
TO 8 FT. LBS. (10.8 Nm.) EACH.
RE-ASSEMBLY
12