Ramsey Winch H-400 LEVER (JERR-DAN) - Manual (Page 5)

8. Push Accessory wire from ignition and other end
of Red wire into plastic Splice (item #14-10).
9. Fold splice clip over itself and snap closed.
10.Route wires from Rocker Switch down the
handles bars. Turn the handle bars fully right and
left to ensure plenty of clearance.
11.Make sure wires are not drawn taut across any
surfaces that could damage them. Use cable ties
to anchor wires. Tie off excess.
Connect Wiring to Solenoid
C
AUTION
: T
IGHTEN NUTS ON TERMINAL STUDS TO
35-40
IN - LBS . (4-4.5 N M ) TORQUE . D O NOT OVER - TIGHTEN .
1. Connect Red Battery Lead (Item #13-2) between
“A” terminal on Solenoid and positive (+) vehicle
battery terminal.
2. Connect Black Motor Lead (item #13-4) between
#2 terminal on motor and C terminal on solenoid.
Connect Black w/Yellow Stripe Motor Lead (item
#13-1) between #1 terminal on motor and B
terminal on solenoid.
3. Connect Black Battery Lead (item #13-3) to “E”
terminal on Solenoid and route to negative (-)
vehicle battery terminal but do not connect.
4. Plug Yellow wire from switch into right terminal
(terminal above black with yellow stripe motor
lead). Plug Green wire from switch into left
terminal (terminal above black motor lead).
Finish Installation
1. Confirm that winch clutch is disengaged.
2. Connect negative (-) battery cable to vehicle
battery. Connect Black Battery Lead from winch
to negative (-) vehicle battery terminal.
3. With ignition switch OFF, press Rocker switch to
“OUT”—winch should not operate. If the winch
does operate with the ignition off, confirm that
proper accessory wire from ignition was spliced.
4. Spool a few feet of cable out by hand. Engage
winch
clutch.
5. Turn ignition switch ON and press Rocker switch
to “OUT”—winch should spool cable out.
6. If winch does not operate with ignition on, check
wiring to the schematic on page 6.
7. If winch spools cable IN instead of OUT, turn off
ignition and reverse yellow and green wires on
solenoid.
Rocker Switch
Operation
Press Rocker Switch toward
“IN” position to spool cable
“IN” and press Rocker Switch
toward “OUT” position to spool
cable “OUT”.
5