Ramsey Winch RPH 8000T - Manual (Page 12)

11
Remove o-ring (item #36) and bushing (item #15) from motor end bearing (item #7). Press new bushing onto
end bearing and dip o-ring in oil and seat into groove of end bearing. Remove seal (item #45) from gear
housing end bearing (item #8). Loosen nut (item #27) and remove nylon setscrew (item #22) and remove ring
gear (item #6) from gear housing end bearing, if necessary. Remove bushing (item #16) from gear housing
end bearing (item #8). Press new bushing (item #16) into place in end bearing. Install ring gear and nylon
setscrew and nut. Ring gear must be fully seated in gear housing end bearing (item #8) and slot in ring gear
must NOT be aligned with clutch shifter hole. Install new seal in gear housing end bearing, with sharp edge of
seal outward.