Ramsey Winch PROFILE 6000/8000T - Manual (Page 5)

5
Attach fairlead to channel using hardware furnished with
winch. Attach winch to channel. Thread capscrews with
lockwashers through mounting holes in channel and into
winch feet (see Figure previous page).
Substitution of attaching hardware items (bolts, nuts or
washers) different from those supplied with your winch
and mounting kit can lead to failure causing damage or
serious injury (use SAE grade 5 bolts or better and
torque to 34 ft.lbs.).
Place end of wire rope through fairlead and attach cable
hook. Use clevis pin and cotter pin.
To mount Solenoid Assembly, use included Solenoid
Mounting Bracket. Mount bracket to tie bar using (1)
1/4-20NC x 1” capscrew in place of 3/4” tie bar cap-
screw. Install bracket to back of solenoid using included
nuts and lockwashers.
When mounting winch, connect labeled motor leads
coming from solenoid assembly to appropriately marked
motor terminals as shown lower right. Tighten nuts on
motor terminals securely. Attach solenoid ground wire
to ground bolt located at bottom of motor (Battery
ground wire is already installed to grounding bolt on
motor).
2 1 A
View A-A
A
A