Ramsey Winch FORD GRILL GUARD KIT 295917 - Manual (Page 6)

KI-913347-0301-B 5
Step 9
Note: You will need assistance for this step.
Have someone steady the center unit while you insert
winch mounting channel #2 between side plates of center
unit #3. Channel shims #19 are inserted between the end
of the channel and the side plate of the center unit on both
sides. Use a rubber mallet to tap the channel into place.
Secure channel using (2) 3/8-16NC x 1-1/4 lg. hx.hd.
capscrews #10 with locknuts #14 (each side).
Step 10
Insert the lower tabs of the center unit through the cutouts in the bumper. Position upper shims
#20 on top of the frame mounting brackets, then secure the channel to the frame mounting
brackets (Figure 16). Use (2) 3/8-16NC X 1-1/4” capscrews #10 with locknuts #14 each side. Do
not tighten hardware. Slip lower shim #22 between the lower tab on side plate and the frame
mounting bracket (Figure 17). Install (2) 3/8-16NC X 1-1/4” capscrews #10 through lower holes
in L.H. side plate and frame mounting bracket (Figure 17). Secure with nuts #14. Repeat for
R.H. side.
Tighten all hardware to proper torque value. (See Torque Value Chart, page 9).
Figure 15
Figure 16
Figure 17