Ramsey Winch FORD GRILL GUARD KIT 295917 - Manual (Page 2)

KI-913347-0301-B 1
Step 1
Unplug fog lights, if so equipped and remove vehicle bumper. (Figure 1 & 2).
Step 2
Modify bumper (Figure 3) to allow for frame mounting brackets. First, find the center of the
vehicle bumper. Measure over toward the driver’s side 16.44” and mark the outside edge of the
cutout. Measure back toward the center of the vehicle .5” and mark the inside edge of the
cutout. Measure down 8.00” from the highest point at the top of the bumper and make a mark.
This will be the top of the first cutout. Next measure 4.00” down from your first mark and locate
the bottom of the cutout. Using a keyhole saw or utility knife, cut through the bumper. Ragged
edges can be smoothed using a file or sandpaper. Repeat for the passenger side cutout. When
finished, cutouts should be spaced 32.875” from outside edge to outside edge.
Figure 1 Figure 2
Figure 3
.5”
4.00”
8.00”
16.44” 16.44”
C
L