Ramsey Winch JEEP GRILL GUARD/SPORT BAR KITS 295241 & 251062 - Manual (Page 6)

5
Step 5 - Electrical Connections
Refer to the winch owner’s manual for your specific winch for instructions on electrical connections.
HINT-Lubricate inside of boots with Silicone Spray to ease installation.
Step 6 - Mounting Winch Plate
1. Check to verify all wires are not pinched and are free from all sharp edges and engine components.
2. Align the six (6) attachment holes for mounting plate.
3. Front two (2) holes each side - Loosely install 1/2 capscrews, lockwashers and flat washers (#5, #9,
#18).
4. Loosely install M10 capscrew, lockwasher & flat washer (#8, #13, #17) each side.
5. Tighten all hardware per Torque Reference Chart page 2.
Step 7 - Battery Power Feed
1. Route both red (+) and black (-) wires from winch to vehicle battery - Five (5) cable ties (#15) are
supplied to kit, at this time select safe locations to insure good cable routing to battery.
2. Secure Battery Feed Wires at this time to vehicle.
3. Connect RED WIRE from Winch to (+) Battery Terminal using Spacer (item #19) and existing nut.
Connect BLACK WIRE from Winch to (-) Battery Terminal using Spacer (item #19) and existing nut,
as shown below.
4. Check Winch Operation per Winch Owner's Manual.
5. If inoperable, re-check ALL electrical connections.