Ramsey Winch FORD WRAPAROUND KIT 295346 - Manual (Page 4)

STEP 2
3
Install rear (1) bolt item # 12,16,14 each side of frame and tighten to full torque. Enlarge rectangular
cutout in bumper bracket by 3/4 " at top and 1/4” at bottom, as shown below in REAR VIEW OF
BUMPER.
Attach nut plate (item #2) to inside of each bracket assembly (items #5 & 6) using (2) 1/2-13NC x 1-
1/4 lg. capscrews with lockwashers and flatwashers, each side. While holding bumper in place,
install end of R.H. and L.H. bracket assemblies through bumper and bumper brackets and into ends
of vehicle frame. Make sure that slotted mounting holes on R.H. and L.H. brackets are to the outside.
Secure brackets to front of frame using (2) 1/2-13NC x 1-1/2 lg. capscrews with flatwashers,
lockwashers, and nuts each side. DO NOT TIGHTEN HARDWARE COMPLETELY.