Ramsey Winch FORD SUPER DUTY KIT 295950 - Manual (Page 4)

4
7. Align and tighten hardware on both sides in the following or-
der: (refer to Torque Value Chart at right)
• Tow hook bolts
• Bumper bracket bolts (upper and lower)
• Rear support bracket bolts
• Lower support bracket bolts
• Bolts between channel and grill guard
• Upper support bracket bolts
8. If needed, install the License Plate bracket (item #20) to underside of
Winch Channel using (2) 1/4 bolts, washers, and locknuts (items #7,
8, & 9).
TO INSTALL THE FAIRLEAD AND WINCH, REFER TO THE
WINCH OWNER’S MANUAL.
9. Install the fairlead using hardware furnished with the winch. Note that
the top holes in the channel assembly (item #1)align with the bottom
holes in the roller fairlead.
10. Install the winch in the winch channel using the hardware that comes
with the winch.
11. Refer to the Winch Owner’s Manual for instructions on electrical con-
nections. Be sure cables are not drawn taut across any surfaces
which could possible damage them.
12. Push battery cables into loom (item #18) and slide loom up cables
as close as possible to mounting frame assembly. Secure using ca-
ble ties (item #19) at each end of loom. To improve appearance,
wrap ends of loom with electrical tape.
13. Plug remote switch into receptacle on solenoid. Run winch forward
and reverse to check connections. Snap appropriate “IN” and “OUT”
disk into proper thumb cavity, after determining winch operating di-
rection. Do not leave switch plugged in when not in use.
14. Place end of wire rope through fairlead and attach clevis hook. Use
clevis hook and cotter pin (furnished with winch). Install cable ac-
cording to instructions in Winch Owner’s Manual.
Bolt size Torque, ft-lbs Torque, Nm
1/4-20 5 7
3/8-16 34 46
1/2-13 87 118
12mm 60 90
Torque Value Chart