Ramsey Winch FORD QM KIT 251065 - Manual (Page 6)

5
STEP 5
You will need assistance for this step.
Have someone hold receiver assembly #1 between R.H. & L.H. bracket assemblies #3 & #4. Make
sure R.H. and L.H. brackets are installed so that slotted mounting holes are on the outside.
Insert (1) 1/2-13NC x 1-1/4 lg. capscrew #7 through rear hole in R.H. bracket #3. Secure using
lockwasher #10 and nut #8. Repeat for L.H. bracket #4.
Next, insert (1) 1/2-13NC x 1-1/4 lg. capscrew #7 through lockwasher #10, front hole of R.H. bracket
#3, and into nutsert in receiver.
Repeat for L.H. bracket #4.
Tighten all 1/2" hardware to 87 ft.lbs. (118 Nm) each. License plate can be mounted to receiver using
(2) 1/4-20 x 1/2 lg capscrews #5 with lockwashers #9, as shown below.
Install receiver cover #12 as shown.