Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295946 & 295947 - Manual (Page 6)

13. Install winch channel to center unit using (2) 3/8” x 1 cap-
screws (item #10), (2) 3/8” locknuts (item #14), and chan-
nel gasket (item #20) on each side. Attach loosely.
14. Install center unit to upper brackets using (1) 3/8” X 1 cap-
screw (item #10), (1) 3/8” locknut (item #14), and upper
mounting bracket gasket (item #22) on each side. Attach
loosely.
15. Install center unit to lower brackets using (2) 1/2” x 1-1/2
capscrews (item #12), (2) 1/2” locknuts (item #16), and
lower mounting bracket gasket (item #21) on each side.
Attach loosely.
6
HOLES FOR
WRAPAROUND
UNIT
HOLES FOR
LITE TUBES
If installing Grille Guard only, skip steps 16-
18.
16. Remove 3/8” capscrew that attaches Center Unit to
Upper Mounting Bracket.
17. Install Wrap Around Right and Left units (Items #27
and #28) to side plates of center unit using (2 per
side) 1/4” capscrews (Item #32) and lock nuts
(Item #33) with wraparound shim (Item #31) and
(2 per hole) washers (Item #34). See previous page
for location of mounting holes. Re-install 3/8” cap-
screw and locknut through Upper Mounting Bracket,
side plate of Center Section Assembly, and Wrap
Around units.
18. Install Headlight Grille Right and Left units (Item #29
and #30) to Wrap Around units and side plates of
Center unit using (2) 1/4” x 1-1/4” capscrews (Item
#32), and lock nuts (Item #33) with washers (Item
#34). Far end of Headlight Grille units will snap into
Wrap Around units.