Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295944 & 295945 - Manual (Page 4)

4
1. Bolt the Upper Mounting Bracket (item #5) to the
underside of the frame as shown using existing
hardware. Attach the Upper Support (item #7) to
the Upper Mounting Bracket using (2 per side) 3/8
x 1-1/2” capscrews (item #12), (2 per side) 3/8
locknuts (item #16), and (4 per side) 3/8 flat
washers (item #13). Do not tighten until later.
2. The other end of the Upper Support (item #7)
should protrude through the grille as shown at
right.
3. Lift center unit (item #1) into place between lower
mounts (with center unit inside the lower brackets).
Lift winch channel (item #2) between lower mounts.
Place channel and lower mount gaskets (item #20)
between center unit and lower mounts, and between
channel and lower mounts. Secure using (2 per side)
3/8 x 1-1/4” capscrews (item #10), (4 per side) 3/8
washers (item #13), and (2 per side) 3/8 locknuts
(item #16). Do not tighten until later.
Secure upper supports to side plates using (1 per
side) upper support gasket (item #21), (1 per side)
3/8 x 1-1/4” capscrews (item #10), (2 per side) 3/8
washers (item #13) and (1 per side) 3/8 locknuts
(item #16). Do not tighten until later.
Repeat steps 1 through 3 for other side.