Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295940 & 295941 - Manual (Page 3)

4. While bumper is still removed from vehicle, fasten
upper support brackets (item #5 & #6) to vehicle
bumper bracket as shown at right using factory
hardware.
The outside edges of the upper support brackets
should be 32 1/4” or less apart (see figure below).
Tighten bumper bracket hardware to proper torque
before re-installing bumper to vehicle. Refer to
Torque Value Chart for proper torque.
Note: The outer edges of the upper brackets should
be 32 1/4” or slightly less apart and the inner
edges of the lower brackets should be 32 7/8” or
slightly more apart in order to attach the center unit
to them. Because the mounting hardware for these
brackets need to be tightened prior to attaching the
center unit to them, make sure the spacing is cor-
rect before you tighten the mounting hardware.
Once the bumper is re-installed, it will not be possi-
ble to adjust the mounting hardware for these
brackets.
3